Inner body repair panels, rear section - TR6
spare wheel tray
Requires: 1
boot floor to chassis frame
Requires: 2
wiring loom securing
For welding to inner wing and inner sill.
electrical earth
For welding to LH inner wing
Requires: 1
fuel tank support, LH
Requires: 1
fuel tank support, RH
Requires: 1
vertical squab support
Carburettor to CC32142, P.I. to CP26998
Requires: 2
vertical squab support, LH
Carburettor from CC50001, P.I. from CP50001
Requires: 1
vertical squab support, RH
Carburettor from CC50001, P.I. from CP50001
Requires: 1
LH rear floor to wheel arch
Requires: 1
RH rear floor to wheel arch
Requires: 1
rear. Please note: The assembly includes the brackets to which the rear cockpit trim panel/'fuel tank board' is secured. It does not, however, include the rear axle differential cover 'bulge', which must be recovered from the old rear seat pan being replaced and welded to the new panel
Requires: 1
to rear floor
Requires: 2
fuel tank to body
Requires: 2
securing seat belt on wheel arch
Requires: 2
securing seat belt on inner sill
Requires: 2
LH rear axle bump stop
Requires: 1
RH rear axle bump stop
Requires: 1
rear tunnel cover to heelboard
Requires: 1
rear
Requires: 1
for anchoring handbrake lever
Requires: 1
handbrake cable - made from cardboard
Alternatives
Requires: 1
handbrake cable - made from fibreglass
Alternatives
Requires: 1
two piece plastic replacement
Alternatives
Requires: 1
one piece plastic replacement
Requires: 1
one piece fibreglass replacement
Alternatives
Requires: 1
on gearbox tunnel for speedo cable access. Fibreglass reproduction
For speedo cable access
Requires: 1
For speedo cable access
Requires: 3
inner sill to LH rear chassis outrigger
Requires: 1
inner sill to RH rear chassis outrigger
Requires: 1
inner sill to front chassis outrigger
Requires: 2
110 pieces, imperial and metric, No. 4 to 3/4" and M6 to M18, 2 tap wrenches, 2 die holders, tungsten steel
Comes in a nicely finished metal box
Requires: 1
