Inner body repair panels, rear section - TR5 and TR250
LH rear
OE version to adapt seat belt bracket
Requires: 1
RH rear
OE version to adapt seat belt bracket
Requires: 1
LH rear - variant without bulge for seat belt bracket
Requires: 1
RH rear - variant without bulge for seat belt bracket
Requires: 1
spare wheel tray
Requires: 1
boot floor to chassis frame
Requires: 2
wiring loom securing
For welding to inner wing and inner sill.
LH fuel tank support
Requires: 1
RH fuel tank support
Requires: 1
vertical squab support
Requires: 2
LH rear floor to wheel arch
Requires: 1
RH rear floor to wheel arch
Requires: 1
rear quarter panel
Requires: 4
fuel tank to body
Requires: 2
rear. Please note: The assembly includes the brackets to which the rear cockpit trim panel/'fuel tank board' is secured. It does not, however, include the rear axle differential cover 'bulge', which must be recovered from the old rear seat pan being replaced and welded to the new panel
Requires: 1
to rear floor
Requires: 2
rear tunnel cover to heelboard
Requires: 1
handbrake cable - made from cardboard
Alternatives
Requires: 1
handbrake cable - made from fibreglass
Alternatives
Requires: 1
for anchoring handbrake lever
Requires: 1
Requires: 1
inner sill to LH rear chassis outrigger
Requires: 1
inner sill to RH rear chassis outrigger
Requires: 1
inner sill to front chassis outrigger
Requires: 2
two piece plastic replacement
Alternatives
Requires: 1
one piece plastic replacement
Requires: 1
one piece fibreglass replacement
Alternatives
Requires: 1
on gearbox tunnel for speedo cable access. Fibreglass reproduction
Requires: 1
Requires: 3
securing seat belt on wheel arch
Requires: 2
securing seat belt on inner sill
Requires: 2
LH rear axle bump stop
Requires: 1
RH rear axle bump stop
Requires: 1
