Cylinder head - 8 cylinder engine
grey
Requires: 1
rocker cover to cylinder head - short
Requires: 4
rocker cover to cylinder head - long
Requires: 4
ignition leads - LH
Requires: 1
retaining mounting igniton leads
Requires: 5
rocker shaft
Requires: 4
LH side, made from alloy - use with push rod 369293 (don't use the standard push rod)
Requires: 8
RH side, made from alloy - use with push rod 369293 (don't use the standard push rod)
Requires: 8
inlet manifold - standard tin specification
Requires: 1
inlet manifold - modern Composite gasket
Requires: 1
inlet manifold - modern Composite specification
Requires: 1
inlet manifold gasket ends - standard specification
Requires: 2
inlet manifold gasket ends - modern Composite specification
Requires: 2
exchange. Complete with valve guides, valves and springs
Requires: 2
new item. Bare head with valve guides, but less valves and springs - compression ratio: 8.25:1
Requires: 2
made from sheet metal. Bore size: 89.9 mm, thickness: 0.2"
Requires: 2
classic soft material gasket on metal layer. Bore size: 89.9 mm, thickness: 0.43"
Requires: 2
Composite specification with partial serigraph covering. Bore size: 88.9 mm + 0.5 mm, thickness: 0.47", built in thickness: 0.47"
Requires: 2
cylinder head - is attached to the front
Requires: 1
tapped for screw securing dipstick tube bracket
Requires: 1
Requires: 1
stainless steel, diameter: 1.57"- for 8.13:1 compression engines
Requires: 8
stainless steel, diameter: 1.34" - for 8.13:1 compression engines
Requires: 8
inlet and exhaust valve. Steel type
Requires: 16
with tin head gaskets
Requires: 1
with soft material head gaskets on metal layer
Requires: 1
