Hub, shock absorber and wishbone
differential and rear suspension. used item, sandblast and black powder coated
Requires: 1
rear suspension craddle - high quality aftermarket product
Requires: 4
rear suspension craddle - high quality aftermarket product
Requires: 4
rear suspension craddle - uprated
Requires: 4
rear suspension crossmember
Requires: 1
drive shaft to differential
Requires: 2
drive shaft, splined
Requires: 2
drive shaft - greaseable type with 106.3 mm span width and 30.2 mm cup diameter
Requires: 4
drive shaft - greaseable heavy duty type with 106.3 mm span width and 30.2 mm cup diameter
Requires: 4
drive shaft outer - with grease hole
Requires: 2
rear suspension. Variant without hole for ABS sensor
Requires: 2
inner oil seal - rear suspension
Requires: 2
rear suspension wheel bearing - inner
Requires: 2
rear suspension wheel bearing - outer
Requires: 2
rear suspension
Requires: 2
for outer oil seal at rear suspension
Requires: 2
right hand rear, 52 mm
vehicles with wire wheels
Requires: 1
left hand rear, 52 mm
vehicles with wire wheels
Requires: 1
rear suspension
vehicles with disc wheels
Requires: 2
rear hub
vehicles with disc wheels
Requires: 10
inner trailing arm - this kit services one side of the vehicle
Requires: 2
trailing arm inner - length: 11.46"
Requires: 4
trailing arm inner bearing - inner
Requires: 8
for the sealing ring of the inner trailing arm bearing
Requires: 8
retaining trailing arm bracket - length: 7/8"
Requires: 2
retaining trailing arm bracket - length: 3/4"
Requires: 2
trailing arm bearing, outer position
Requires: 4
trailing arm outer
Requires: 4
outer trailing arm - this kit services one side of the vehicle
Requires: 2
rear shock absorber upper and lower mounting
Requires: 4
rear shock absorber upper and lower mounting. Variant with inner sleeve
Requires: 8
upper shock absorber mounting
Requires: 4
lower shock absorber mounting
Requires: 2
rear coil spring - bottom. Dimensions: 56 mm ID and 80 mm OD
Requires: 4
spring seat 'rear coil spring - 1 half. Fits to genuine Jaguar dampers only
Requires: 8
spring seat 'rear coil spring - 1 half. Fits to Limora damper 200448 and 1579 only
Requires: 8
rear radius arm, rear. Uprated 'comfort' type
Requires: 2
rear radius arm to trailing arm
Requires: 2
rear radius arm, front - uprated 'comfort' type
Requires: 2
1.7/8" x 7/16 UNF with hole for lock wire - radius arm bracket to chassis. Please note: must be used with thread lock at the point of assemble
Requires: 2
