Fuel tank, fuel pump an sender - 3.8 Series 1 (1961-64)
conveyor module inside the tank - reconditioned, in exchange
E-Type 3.8 (1961) - OTS to chassis no. 850091 and 875385, FHC to chassis no. 860004 and 885020
Requires: 1
conveyor module inside the tank - reconditioned, in exchange
E-Type 3.8 (1961-64) - OTS from chassis no. 850092 and 875386, FHC from chassis no. 860005 and 885021
Requires: 1
conveyor module inside the tank - modern replacement for the original submersible pump
E-Type 3.8 Series 1 (1961-64)
Requires: 1
to replace the fuel tank mounted petrol pump. In this conversion kit, an electronic pump together with a pick up pipe replaces the original submersible pump - for vehicles with positive earth
E-Type 3.8 Series 1 (1961-64)
Requires: 1
retaining submersible pump to fuel tank
Requires: 8
retaining submersible pump to fuel tank
Requires: 8
retaining fuel pipe to submersible pump
Requires: 1
retaining fuel pipe to submersible pump
Requires: 2
from submersible pump to bulhhead connector
Requires: 1
fuel pipe to bulhhead connector
Requires: 2
for fuel pipes in boot area
Requires: 1
made from mild steel. Indentify by single vent breather, capacity: 14 gallons
Requires: 1
made from galvanised mild steel with black finish. Indentify by single vent breather, capacity: 14 gallons
Requires: 1
reproduction - please note: The float arm needs to be bend to the OE arm specification
Requires: 1
retaining tank sender to tank
Requires: 6
for filter in fuel tank - high qualitiy variant in Viton®
Requires: 1
fuel tank sump x 1.1/4" - must be soldered into the fuel tank
Requires: 1
at the suction pipe end in the tank
Requires: 1
reproduction with stainless steel mesh
Requires: 1
fuel filler neck - improved reproduction made of silicone
Requires: 1
chromed, round knurled execution - non locking
Requires: 1
in stainless steel with round knurled execution - non locking
Requires: 1
fuel tank retaining, front position
Requires: 1
fuel tank retaining, centre position
Requires: 1
