Wiper motor, wheel box and windscreen wiper Series 2 (1968-70)
with wheel boxes assembly, but without link
All Series 2 OTS and FHC models
Requires: 1
with wheel boxes assembly, but without link
All 2+2 models
Requires: 3
to wheel box
All 2+2 models
Requires: 1
set with bezel, nut and gasket
All Series 2 OTS and FHC models
Requires: 3
windscreen wiper motor to wheel box
Requires: 1
between wiper motor and mounting plate
All Series 2 OTS and FHC models
Requires: 1
between wiper motor and mounting plate
All 2+2 models
Requires: 1
two speed type with round body, voltage: 12. Supplied less drive gear - reconditioned, in exchange
Requires: 1
stainless steel, length: 10.5", angle of crank: 10° left. Feature: 5.2 mm bayonet fitting for wiper blade, push-on fitting to wheel box
All RHD OTS and FHC models
Requires: 3
stainless steel, length: 10.5", angle of crank: 10° right. Feature: 5.2 mm bayonet fitting for wiper blade
All LHD OTS and FHC models
Requires: 3
stainless steel, length: 14.2", angle of crank: 0°. Feature: 7 mm bayonet fitting for wiper blade
All RHD und LHD 2+2 models
Requires: 1
stainless steel, length: 14.2", angle of crank: 10° left. Feature: 7 mm bayonet fitting for wiper blade
All RHD 2+2 models
Requires: 1
stainless steel, length: 14.2", angle of crank: 10° right. Feature: 7 mm bayonet fitting for wiper blade
All LHD 2+2 models
Requires: 1
stainless steel, length: 12" - for flat and curved screens. Feature: offset hinge for wiper arm with 5.2 mm bayonet fitting
All OTS and FHC models
Requires: 3
'speedbalde' type with dual stainless wire style, length: 14" - for flat and curved screens. Feature: centre hinge for wiper arm with 7 mm bayonet fitting
2+2 models
Requires: 2
stainless steel, length: 14" - for flat and curved screens. Feature: centre hinge for wiper arm with 7 mm bayonet fitting
2+2 models (1967-70)
Requires: 2
with base plate and wiring - Lucas 14W wiper motor
Requires: 1
