Radiator and radiator hoses - 4.2 Series 1 and RHD Series 1.5
new item with high efficiency core
E-Type 4.2 Series 1 with manual transmission (1964-68)
Requires: 1
standard specification - reconditioned, in exchange
E-Type 4.2 Series 1 with manual transmission
Requires: 1
alloy, lightweight type with high efficiency core
E-Type 4.2 Series 1 with manual transmission (1964-68)
Requires: 1
made from aluminuim with polished finish, lightweight type with fantastic finish and high efficiency core - made in the UK
E-Type 4.2 Series 1 with manual transmission (1964-68)
Requires: 1
new item with standard copper core
Series 1 4.2 litre 2+2 models with automatic transmission to 1E77644 (1966-67)
Requires: 1
alloy, lightweight type with high efficiency core
Series 1 4.2 litre 2+2 models with automatic transmission to 1E77644 (1966-67)
Requires: 1
retaining bracket to radiator cowl
Requires: 2
retaining bracket to radiator cowl
Requires: 2
retaining bracket to radiator cowl
Requires: 2
radiator - aluminium reproduction
Requires: 1
in stainless steel - under radiator
Requires: 1
radiator cowl to radiator - in stainless steel
Requires: 2
retaining air duct panel to radiator
Requires: 2
retaining air duct panel to radiator
Requires: 2
engine cooling system. Steel version, finished in grey hammerite
Requires: 1
engine cooling system. Brass version of the original tank
Requires: 1
engine cooling system. Ultra-light aluminium version of the original tank
Requires: 1
radiator - pressure: 7 PSI, 3/4" depth
Requires: 1
radiator - pressure: 13 PSI, 3/4" depth
Requires: 1
retaining bracket to expansin tank
Requires: 2
fan motor. Variant with single spade terminal. Switches on at 86 C° and off at 74 C°
Requires: 1
fan motor. Variant with single spade terminal. Switches on at 90 C° and off at 80 C°
Requires: 1
fan motor. Variant with twin spade terminal
Requires: 1
fan motor. Complete unit with gasket and twin spade connector
Requires: 1
reconditioned, in exchange
Requires: 1
retaining heater motor heater motor
Requires: 4
retaining heater motor heater motor
Requires: 4
radiator to epansion tank, RH
Requires: 1
radiator to epansion tank, LH
Requires: 1
between header tank and thermostat housing
Requires: 1
worm type. Retaining hose between header tank and thermostat housing
Requires: 2
radiator to water pipe - lower position
Requires: 1
conecting bottom radiator hoses - reproduction in stainless steel
Requires: 1
between water pump and water pipe
Requires: 1
worm type. Retaining water pump to hose
Requires: 1
worm type. Retaining bypass hose to radiator and water pipe
Requires: 2
worm type. Retaining hose to inlet manifold
Requires: 1
worm type. Retaining hose to water pipe
Requires: 1
with fabric interlayer for reinforcement
Requires: 1
made of high quality silicone. Set with 13 lines incl. heater hoses
Requires: 1
between radiator and bypass hose to inlet manifold
Requires: 1
